Hose Builder – Finishing Lines
Cart 0
Cart 0

Custom Hose Builder

Custom Built Hoses to Your Specs

1

Hose Length

Measure port-to-port along the routing path. Range 6"–200".

in

Recommended measuring procedure using a flexible material such as string, rope or wire. Run from Port A to Port B along the routing path that you would like the hose to run. Mark length and lay out on tape measure for overall length measurement.

  1. Lengths should be measured by the entire length of hose assembly. From tip of hose end to tip of hose end.
  2. For hose ends with a bend angle, the measurement should be to the center of the bend radius or alignment with the flare seat. This could also be considered as the center of the port to which you are connecting.
  3. For Banjo hose ends measurements should be to the center of the banjo hole.
2

Hose Diameter

Choose your hose size

3

Hose Ends

4

Colors

All hose is PTFE core and stainless braided reinforced. The color choice is a poly jacket covering over the stainless braided layer.